|
|
| |
Engine Repairs and Reconditioning
I will repair any two or four-stroke model engine, glow or gas. I
will
also do light machine work if necessary for the repair. Such work as
the
following can be done:
-Bearing replacement, two or four stroke.
-New piston rings, including cylinder honing.
-Removal of frozen bolts or screws without damage to the engine.
-Complete engine rebuilding to restore performance.
-Damaged engine repair.
-Machining of damaged mating parts if possible.
As I have to buy parts at retail just like you do, there is no
markup
for parts and I will use yours if you have them (assuming they are
correct). Shipping costs for parts is also a pass-through. Bearings
will
come from Boca Bearing, other parts will be ordered from the
appropriate
distributor.
Labor for any service is $25/hr, including any cleanup necessary
prior
to disassembly. A typical two-stroke bearing replacement in an
otherwise
good engine will take about an hour or less, including cleaning (you
can
save a buck or two by cleaning it up first), plus roughly $12 to $15
for
the bearings. If you are in a hurry I can pick them up at Boca
Bearing,
but I’ll charge you $15/hr for my time. Gas is expensive these days.
I
will give you a rough estimate after seeing your engine, but you
don’t
always know what you’ll find until its apart. If I feel its not
repairable, or parts cost is excessive, I will not attempt the
impossible. Often its cheaper to replace than repair. You will only
owe
me for my time to tear it down.
As to my qualifications:
Motorcycle mechanic
Foreign car mechanic
Alfa Romeo race engine builder
Prototype auto chassis fabricator
Aircraft builder and mechanic
Civil engineer
Over 50 years messing with model airplanes.
Call me at 561-395-4179 or,
Andy JohnsonPOSTED 5-22-07
|
 |
kyosho edge 540
new os 70 4stroke
jr dig servos
6v batt
alum spinner
only 10 flights
400.00 rtf less reciver
sky bolt bi plane
os 91 4stroke
jr dig servos
6v batt
alum spinner
400.00 rtf less reciver
for more info call chris at 561-255-9911 POSTED 3/17/08 |
|
|
1.- Ultra
Stick 60 with a Saito 100. Very well assembled by me, the engine is new
too, has the factory recommended break in, and both have only one 10
minutes successful test flight. Horizon Hobby is asking $420 for this
combination, unassembled and w/o S&H. I am accepting $300.00 (Firm), and
I will included the 7 new futaba servos, the electric switch and the
high current receiver battery, for additional $50.00 I‘ll include a 4
channel Futaba transmitter and receiver, and it will be ready to fly.
2.-
WindStar Sailplane with an OS10 engine, ready to Flight. Motor has break
in plus 5 successful flights, and model the 5 Flights. Including Radio
system, model ready to fly, I’m asking $50.00.
Vicente
Lanz
561-706-5902 Mobile
561-416-9037 Home
POSTED 4/10/08 |
 |
For Sale:
THE BIKE IS A ULTRA
SLEDGEHAMMER
IT HAS A 113 S and S
MOTOR HAS A 6 SPEED TRANSMISSION
45 DEGREE RAKE
8 INCH OVER ON THE
HANDLE BARS
250 REAR TIRE POLISHED
MOTOR CUSTOM PAINT AND SEAT TO MATCH
CLOSE TO 100 HP TO THE
REAR WHEEL AND IT IS FAST..
asking $22,500
Bob Dimezza
561-441-4879
POSTED 3/3/08
|
|
|
|
| |
I have an E-Flight P-47 Thunderbolt plane fully assembled for sale.
Includes the following all new components. Note that this plane has
some damage but is ready to fly without any problem. You can either
hand launch this plane or use the landing gear.
E-Flight P-47 Thunderbolt
40 Amp E-Flight brushless ESC
E-Flight Park 400 Brushless Outrunner motor (upgraded)
3 each E-Flight micro servos
Spektrum 6100 receiver
Thunder power 3s 2100Mah 11.1 V Battery
Asking price is $250. Call James at 561-255-4398.
POSTED 4/10/08 |
|
I have a brand new Yak with a new moki 1.8 (4.0 hp) 2 stroke engine
for sale. (MINT) with only 10 flights on it. It fly's like a dream. I
have over $1,570.00 into it and need to sell it. I will consider any
reasonable offer. This airplane has all the heavy duty servos and
comes with a high capacity JR receiver battery and a true turn
spinner. I will also include a brand new Futaba 2.4 radio if desired.
Complete turn key model.
Must see to believe, asking $1,070 = $500.00 discount.
Thanks,
Bill Rudolph
cell : 954-612-8513
POSTED 4/2/08 |
|
|
|
 |
Brand new, Never removed from the box,
50CC Yak ARF
A high performance aerobatic airplane, capable
of both precision and 3-D maneuvers. The aircraft builds easily,
quickly and precisely due to state of the art CAD design with Laser
cutting technology, and outstanding craftsmanship.
This 50CC Yak ARF is designed for gas engines in
the 50cc category. It is built with the highest quality balsa/plywood
and is pre covered.
Fuselage length: 2060mm / 81 in
Flying weight: 8000g
Wing Span: 2160mm / 85in
Engine : Gas Engine: 45cc - 50cc
Engine Required: Gas Engine: 45cc - 50cc
Asking $300.00 Firm
Call Jack at 954-261-6343
POSTED 3/31/08 |
 |
For
sale is my 42% aerotech velox. selling because im finishing a new plane
and have to make room for it. this has been my imac competition (only,
no 3d) plane for 2 year now. never been flown hard. flown in the 2007
regional campionship in sportsman. selling complete airframe ready to
fly for $3500. will split it up if wanted, $2300 for airframe and
servos, $1200 aiframe only with hardware. plane has a DA150 and futaba
servos with fromeco batteries and MPI regs, set up for dual recievers.
recievers do not come with plane. any questions please call me at
386-409-9382 or email me. i will get back to you asap.
matt POSTED 3/18/08 |
 |
RC Airplane Lot
All items approximately 5 yrs old and havent been run for around 4
years. Need space in garage.
1 Hobbico Avistar 40 (100 new) good condition rudder corner dented and
some small holes in wing should be an easy patch.
.40 or .46 engine will double check tomorrow (70 - 100 new) with:
Futaba TX6A Radio 6 channel radio digital display w/ battery but
no
charger and 8 channel reciever (150 new)
(4) s3003 servos (11 each new)
1 Undermount stunt plane purchased new at the lakeland air show 5
years
ago ran a few times (compare at 200 new) with:
.52 magnum lx 4 stroke engine (compare at 160 new)
Futaba 4 channel basic transmitter with trainer cord (100 new for
radio 10 for trainer new)
Hitec 8 channel reciever and battery no charger (compare at 60
new)
(5) Hitec hs-422 servos (compare at 12.50 each new)
Field Kit with electronic fuel pump, glow heaters, voltimeter, dc
charger, extra prop.
Adds up to over a 1000 new asking 500. Airplanes are not in running
condition but should not take much to get them there.
Contact Henry at 561 202 4347
POSTED 3/18/08 |
 |
I have the following Blue Angels F-18 foam jet for sale that is from
Hobby Lobby. Includes radio, battery, receiver, charger and is ready
to fly. Plane is fully assembled and in very good condition with no
damage. Includes an additional Red F-18 Diamond Back for spare parts.
Asking price is $180.00. Call James at 561-255-4398.
POSTED 4/10/08 |
 |
For Sale !
Aero Pro Laser
200 87” W.S.
A Sweet Flying, Easy To Land Plane
·
BME-50
·
APC Prop
·
Tru-Turn Spinner
·
Custom Graphics
·
Premium Servos
·
Dual Batt Packs
·
Dual Batt Switches
·
On-board Kill Switch
·
Never Crashed
·
RTF less Rx.
$800.00 with BME-50
$550.00 less engine
Howard Leipzig 561
371-0269
Posted 3/24/08 |
 |
I have the following Hangar 9 P-51 150 ARF for sale. I started the
project attaching the flaps and alerons only. All else is ready to be
completed and new in box. All components are new and have never been
used.
Comes with the following:
JR 791 Heavy Duty retract servos (one is reversed), 2 each
DS821 servos, 4 each installed
Sanyo Nimh 5s 2700mah battery for retracts
JR Nimh 4s 1650 battery for receiver
Asking price is $700. Call James at 561-255-4398.
Posted 5/10/08 |
| |
FOR SALE 1) .46 size Thunder Tiger Tiger-Bipe in
good condition w/servos and
OS .46 LA RTF minus receiver and battery. Flies very nice and still
looks nice for $140.00
2) 27% Hanger 9 CAP 232 airframe only
with two wings in fair condition but very fly-able for $125.00
OBO Red, white and
checkerboard. It's setup for a Saito 1.80. Good deal for someone who
wants to get going in 1/4 scale cheap. It needs to go...no room.
3) 46 size Global Hobbies Decathlon with
AXI brushless, Jeti 40A ESC, BEC, Thunder Power 5000Mah 3S2P in
excellent condition RTF minus receiver. Flies and looks great. The
battery for this plane cost $150, AXI motor $85, Jeti controller
$105. I'll sell it RTF minus receiver for $235.00
4) Bridi Utter KAOS .60 size. OS 60 rear
exhaust with tuned pipe. Plane in good condition, some hanger rash,
never crashed. Motor needs bearings. Plane flies great and always
got lots of attention at the field. RTF minus battery and receiver.
$150.00
5) Thunder Tiger Velocity flying wing,
electric pusher, good condition, great flyer. E-Flight brushless
"SIX" 3000, two HS 55 servos. No ESC or battery. I use a Phoenix
45ESC and a TP 3S1P 2100 li-po in it. Very aerobatic, good
glide..does about 90-100mph. Comes with second complete partially
built airframe for $100.00.
6) 12th
scale F4F Bearcat 2610 combat plane, built up wood, covered but
never flown, with MVVS .20 motor. Beautiful plane for someone who
wants to finish it....needs servos, radio and tank. $100.00
7)
GWS Funny Park park flyer, excellent
condition, E-Flight brushless 400, Eflight 25AmpESC, 1200Mah 2S1P
Lipo, GWS servos, receiver RTF. install your crystal and fly.
$125.00 Rip the electronics out of
this plane and put it in the Extra 300 below;
8) Wattage
Extra 300 ARF, new in box, with brushed cobalt motor, $75.00,
beautiful, all wood kit covered with monocote needs brusless setup.
9)
Various brushless motors, some ESC's, some new-in-box kits and quite
a few glow motors both new and used, to many to list.
There
are many planes not listed here I'd probably part with and
I'd be willing to make good deals on things sold as a bundle. None
of this stuff is junk, I've already thrown the junk away. I just
need room to build and fix and I don't have that now..........
You are welcome to come by anytime and
take a look. I guess I will consider trades but understand I'm
trying to move stuff out....... :-)
Thanks
a bunch........Swamp Thing
Jeff Benko
561.386.6795
JBenko@Network-Advise.com
POSTED 4/3/08 |
| |
All Items
less than 6 months old
Real
Flight R/C Simulator G4 controller & Program …$125 original cost
$212
Futaba
4EXA 4 channel FM…..$75 original cost $140
2 Prophet
Battery Chargers AC/DC 4-7 cell peak prediction chargers
for Ni-Cd
& NiMH Battery Packs …$45 for both original cost $38.00 each
Aluminum
transmitter case … $25 original cost $52.00
4
electrifly 8.4v 3000mAh NiMH batteries $50 for four original cost
$100
Trainer
cords, 2 props, battery tester, etc. - best offers
Electristar needs work all servos OK – open to offers.
Call Mel at
561-495-0633
POSTED 4/9/08 |
| |
IS YOUR
GLOW PLUG HOLE STRIPPED OUT ?
$20. will fix your motor to be stronger
than new.
You must do the cleaning and disassembly
and deliver only the clean head to me for machining work.
If you choose to mail it to me…that’s
fine, but add on another $5.00 for me to get it packed and shipped
back to you.
That’s all it takes…and it’s good, it’s
cheap and it’s fast.
One day turnaround, or quicker if you
are really in a hurry.
If you are unable to do the disassembly,
I can do it for you, but there will be an additional $25. charge for
cleaning, disassembling, and reassembly, and the turn around time will
be just a little longer.
Call Jim…561 789-2006
Boca Raton, FL.
POSTED 4/9/08 |
| |
Evolution 58cc gas engine. Was in a 29% Edge. Includes wrap around
pitts
muffler, zinger prop and spare hardware and plug. $375. Doug
POSTED 5/13/08 |
|
